Transfer gear pumps KF are used for pumping a wide variety of fluids.
Transfer gear pumps KF are distinguished especially by their wide range of

variants which are assembled as required on the modular principle and also

permit subsequent upgrade.
The pumps are also suitable for media with low lubricating properties.
The standard housing sections are of grey cast iron.
The gear units are manufactured from high-strength case-hardening steel,

hardened and mounted in special  multi-compound plain bearing bushes.
The standard drive shaft is sealed by rotary shaft lip-type seal.
All pump sizes incorporate helical tooth system.
This feature, combined with special gear geometry,results in extremely low noise

levels and reduced pressure pulsation.

Sealing of the drive shaft:
– Rotary shaft lip-type seal
– Double /triple rotary shaft lip-type seal (Quench)
– Mechanical seal

Standard pumps are equipped with built-in safety valve, pump is directly mounted

with the motor through the shaft coupling and belling house